H12-211 Questions PDF [2023] Use Valid New dump to Clear Exam [Q143-Q166]

Share

H12-211 Questions PDF [2023] Use Valid New dump to Clear Exam

Passing Huawei H12-211 Exam Using 2023 Practice Tests

NEW QUESTION # 143
by LSDB, each router as its own compute a () node of the shortest path tree.

  • A. Leaf
  • B. Specify the root
  • C. Backup
  • D. Root

Answer: D


NEW QUESTION # 144
For a switch running STP, the port can be directly converted to the Disabled state in any state.

  • A. False
  • B. True

Answer: B


NEW QUESTION # 145
Which of the following commands can be used to display the routing table on a Quidway router?

  • A. display ip path
  • B. display interface
  • C. display current-configuration
  • D. display ip routing-table

Answer: D


NEW QUESTION # 146
An IPv4 packet header length field is 20B. and the Iota[ length field is 1500B then what is the packet payload?

  • A. 0
  • B. 20B
  • C. 1520B
  • D. 1480B

Answer: D


NEW QUESTION # 147
An ACL rule is as follows: Which of the following iP addresses can be matched by the permit rule? (Multiple Choice) rub 5 permit ip source 10.0.1.0 0.0.254.255

  • A. 10.0.2.3
  • B. 10_0_1 2
  • C. 10_0.3.4
  • D. 10.0.4.5

Answer: B,C


NEW QUESTION # 148
Huawei router serial interface encapsulation PPP protocol, you need to enter the command interface view is

  • A. encapsulation ppp
  • B. link-protocol ppp
  • C. address ppp
  • D. enable ppp

Answer: B


NEW QUESTION # 149
On the network shown in the figure, if all routers run OSPF, which router is elected as the BDR?

  • A. Router A
  • B. Router B
  • C. Router D
  • D. Router C

Answer: A


NEW QUESTION # 150
Which of the following default action business module ACL is permit?

  • A. SNMP
  • B. Flow strategy
  • C. HTTP
  • D. Telnet

Answer: B


NEW QUESTION # 151
Which of the following type of addresses are not included in the IPv6 address?

  • A. Anycast address
  • B. Broadcast address
  • C. Unicast address
  • D. Multicast address

Answer: B


NEW QUESTION # 152
Link-layer protocol that route, the following statements is correct ().

  • A. where the interface can only be found in the directly connected segment of the route
  • B. can only find a route to the loopback address
  • C. No maintenance
  • D. can only be found in the inter-network routing

Answer: A,C


NEW QUESTION # 153
Refer to the graphic. An administrator has configured RIPv2 in the two routers. What will happen after configuring the following commands: (Choose all that apply)

  • A. RTB will have the route learned from the RTA
  • B. RTB will have no neighbor relationship with RTA
  • C. RTA will have no neighbor relationship with RTB
  • D. RTA will have the route learned from the RTB

Answer: B,D


NEW QUESTION # 154
To support variable length subnet mask, routing protocols are:

  • A. RIP v1
  • B. OSPF
  • C. RIP v2
  • D. IS-IS

Answer: B,C,D


NEW QUESTION # 155
Refer to the graphic. Which statements correctly explains the forwarding behavior between RTA and RTE?
(Choose all that apply)

  • A. When the network uses OSPF, data will be forwarded along the path from via E0/0/1
  • B. When the network uses RIPv2, data will be forwarded along the path via S2/0/0
  • C. When the network uses RIPv2, data will be forwarded along the path via S1/0/0
  • D. When the network uses OSPF, data will be forwarded along the path via S1/0/0

Answer: A,C


NEW QUESTION # 156
In the IEEE 802 system described in Logical Link Control protocol (LLC) sublayer functions, features and protocols is

  • A. IEEE 802.3
  • B. IEEE 802.4
  • C. IEEE 802.5
  • D. IEEE 802.2

Answer: D


NEW QUESTION # 157
Ethernet into VLAN feature, VLAN isolation of ().

  • A. MAC address of the second floor
  • B. two-story single multicast domain
  • C. layer broadcast domain
  • D. Layer 2 multicast domain

Answer: C


NEW QUESTION # 158
The function of OSPF hello packets is (). (multiple choice)

  • A. Publish parameter information such as Router ED and Router Priority.
  • B. Synchronous router LSDB
  • C. Discovering neighbors
  • D. Maintaining neighbor relationships

Answer: A,C,D


NEW QUESTION # 159
When a NAT uses a dynamic address pool, the addresses in the address pool can be reused, that is, the same IP is mapped to multiple intranet IPs at the same time.

  • A. Correct
  • B. Error

Answer: B


NEW QUESTION # 160
As shown in the figure, after the Um routers are configured with OSPF, the administrator configures the
<mlenhinterfaces0f0/1> command on the RTA. The correct description is O (Multiple Choice)

  • A. The neighbor relationship of the two routers will be down_
  • B. RTA wit not send OSPF packets anymore_
  • C. The RTA wit continue to receive and analyze the OSPF packets sent by the RTB.
  • D. The neighbor relationship of the two routers wit not be affected

Answer: A,B


NEW QUESTION # 161
By default, how many seconds is the period of OSPFv3 HELLO packet sending on the Ethernet link?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

Answer: C


NEW QUESTION # 162
Refer to the graphic, the static NAT command is executed on R1. When a PC connected to R1 accesses the Internet, the destination address in the packets does not change.

[R1]interface GigabitEthernet1/0/0
[R1-GigabitEthernet1/0/0]ip address 192.168.0.1 255.255.255.0
#
[R1]interface GigabitEthernet2/0/0
[R1-GigabitEthernet2/0/0]ip address 202.10.1.2 255.255.255.0
[R1]nat static global 202.10.1.3 inside 192.168.0.2 netmask 255.255.255.255
[R1]ip route-static 0.0.0.0 0.0.0.0 202.10.1.1

  • A. False
  • B. True

Answer: B


NEW QUESTION # 163
An ARP request is sent by host A to obtain the destination MAC address of host D.
Which statement is true about regarding the ARP reply?

  • A. The destination MAC address of this frame is the MAC address of Switch A.
  • B. The destination IP address of this packet is the VLANIF1 IP address of Switch A.
  • C. The destination MAC address of this frame is the MAC address of Host A.
  • D. The destination IP address of this packet is a broadcast IP address.

Answer: C

Explanation:
Explanation


NEW QUESTION # 164
80 late, unshielded twisted pair UTP appeared, and quickly get a wide range of applications. UTP advantages:

  • A. producing simple
  • B. cheap
  • C. encrypted using a different cable
  • D. physical topology and logical topology is still a bus

Answer: A,B,C


NEW QUESTION # 165
TFTP protocol is a simple file transfer protocol, which uses () for file transfer

  • A. RTP
  • B. UDP
  • C. TCP
  • D. SIP

Answer: B


NEW QUESTION # 166
......


Huawei H12-211 certification exam is made available in several languages including English, Chinese, Japanese, Russian, Portuguese, French, and Spanish. H12-211 exam is usually administered at Pearson VUE testing centers globally. It is considered proctored and computer-based, and candidates have 90 minutes to complete the exam. H12-211 exam contains 60 questions in a multiple-choice format, and exam takers must attain a minimum score of 60 percent to pass.


Huawei H12-211 certification exam is a vendor-specific certification that is recognized globally. Huawei Certified Datacom Associate-Huawei Networking Technology and Device (HCDA-HNTD) certification validates that the candidate has a comprehensive understanding of Huawei networking technology and device and can apply that knowledge to design and troubleshoot network infrastructure. Huawei Certified Datacom Associate-Huawei Networking Technology and Device (HCDA-HNTD) certification exam is designed for professionals who want to work with Huawei networking products and solutions.

 

H12-211 Study Guide Brilliant H12-211 Exam Dumps PDF: https://www.test4engine.com/H12-211_exam-latest-braindumps.html