Mar-2023 Latest Test4Engine H35-260 Exam Dumps with PDF and Exam Engine Free Updated Today!
Following are some new H35-260 Real Exam Questions!
NEW QUESTION 130
Of the following protections, which items are protected by the double transmission and reception of the electrical layer?
- A. ODUK SN
- B. ODUK Ring Protection
- C. SWSNCP Protection
- D. Client side 1+1 protection
Answer: A,C
NEW QUESTION 131
In the following label operation modes, which options does the PTN device support?
- A. PUSH
- B. POP
- C. SWAP
- D. PHP
Answer: A,B,C
NEW QUESTION 132
Which of the following descriptions of the electrical layer multiplexing and mapping steps of ODU0 is wrong?
- A. After mapping and multiplexing, 34 channels of ODU0 signals can be finally multiplexed into 1 channel of OTU3V signals
- B. After mapping and multiplexing, the 2 ODU0 signals can be finally multiplexed into 1 OTU1IV signal
- C. After mapping and multiplexing of 8 ODU0 signals, it can be finally used as 1 OTU2V signal
- D. After mapping and multiplexing, 80 channels of ODU0 signals are finally multiplexed into 1 channel of OTU4V signals
Answer: A
NEW QUESTION 133
A company has a class C IP address segment 198.160.110.0/24. The company has 6 departments, each department is located in a different subnet, and the number of hosts in each subnet is the same as 25-30. Which of the following can be used as the subnet mask to reasonably plan the P address space?
- A. 255.255.255.224
- B. 255.255.255.128
- C. 255.255.255.0
- D. 255.255.255.192
Answer: A
NEW QUESTION 134
Which of the following statements about the slave subrack SCC function is correct?
- A. Status management of boards from subracks
- B. Handling of Overhead
- C. DCN message forwarding
- D. Protection switching protocol processing of this subrack
Answer: A,B,C
NEW QUESTION 135
NE1 and NE2 are the intersection nodes of the SNCP ring and the SNCP ring, so how many SNCP protection groups and how many unidirectional cross-connects need to be configured on NE1.
Which of the following is correct?
- A. 4,2
- B. 2,4
- C. 4,4
- D. 2,2
Answer: D
NEW QUESTION 136
In which slots are the OptiX OSN 8800 T32 cross-connect boards fixed?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A,B
NEW QUESTION 137
In the MPLS-TPOAM architecture of PTN equipment, what are the functions of network performance maintenance?
- A. LT
- B. LM
- C. DM
- D. LB
Answer: B,C
NEW QUESTION 138
When it is found that the local end reports the ETH_LOS alarm, the fault can be located by the switch-back method. If the alarm disappears after the ODF loops back to the local end, which of the following may be the cause?
- A. The peer board or pigtail is faulty
- B. Device false positives
- C. The local board or pigtail is faulty
- D. Line failure
Answer: A
NEW QUESTION 139
Regarding electrical layer service configuration, which of the following statements is false?
- A. After the logical fiber connection is completed, no path search operation is required, and the OTS path and OMS path can be automatically generated
- B. When the Och service path exists, directly create the OTUk path, and the network management can automatically create the OTUk and 0DUk paths.
- C. If there is an Och service path, you can first search for the OTUk path, create the ODUk service layer path, and then create the Client path.
- D. When the Och service path exists, create an OTUk path directly, and the network management can automatically create the OTUk path
Answer: A
NEW QUESTION 140
Which of the following descriptions is correct?
- A. OptiX PTN supports encapsulating E1 frames of different connections into one PW
- B. SAToP supports time division suppression
- C. One STM-1 channel contains 64 VC12 time slots
- D. SAToP encapsulation type processes the CES service by encapsulating the 32 time slots in the E1 frame as a whole and then transparently transmitting it to the opposite end
Answer: D
NEW QUESTION 141
Which of the following is not included in the function of the Inspector inspection tool?
- A. Collect network element performance data for inspection
- B. Generate an inspection report according to the passing of inspection items and analyze the situation.
- C. Perform inspection tasks from the batch of relevant information obtained from NEs
- D. Support viewing inspection results and importing and exporting inspection data.
Answer: A
NEW QUESTION 142
The router works on the third layer (network layer) of the TCP/IP protocol stack. Which of the following is the main job it completes?
- A. Establish turbulent-to-turbulent connections
- B. Addressing and Routing
- C. Binary Data Streaming
- D. Physical Media Access
Answer: B
NEW QUESTION 143
In the PTNLTE non-load sharing scheme, the main L3 configuration is used to configure the route tracking multi-hop BFD scheme to prevent loops. Which of the following configurations needs to be performed?
- A. The standby L3 configures the standby traceroute BFD to the EPC
- B. The primary L3 configures the backup traceroute BFD to the EPC
- C. Create the BFD between the main L3 Loopback interface device L3 and the EPC port
- D. Create a loopback interface address on the active L3
Answer: B,C,D
NEW QUESTION 144
NE1 and NE2 are the intersection nodes of the SNCP ring and the SNCP ring. How many SNCP protection groups and how many unidirectional cross-connects should be configured on NE1.
Which of the following is correct?
- A. 4, 4
- B. 2,4
- C. 2, .2
- D. 4, 2
Answer: C
NEW QUESTION 145
Any service cross-connect can only be configured in inter-board cross-connect, and does not require the participation of XCS boards
- A. False
- B. True
Answer: B
NEW QUESTION 146
Which of the following is a common wavelength in optical communication?
- A. 850nm.1310nm.1500nm
- B. 800nm, 1310nm, 1550nm
- C. 850nm, 1310nm.1550nm
- D. 850nm, 1330nm, 1550nm
Answer: C
NEW QUESTION 147
When creating a static TUNNEL, you need to specify the interface of the next hop. Which is the displayed address of the next hop?
- A. NEIP
- B. Next-hop interface IP
- C. NE LSR-IP
- D. does not involve
Answer: B
NEW QUESTION 148
On the U2000 network management, you can make an inner ring and an outer ring on the PTNE1 port to facilitate testing
- A. False
- B. True
Answer: A
NEW QUESTION 149
In the WDM transmission system, the main factors that affect the unevenness of the power balance of each channel do not include the following?
- A. The cable attenuation is too high
- B. EDFA gain unevenness
- C. The main channel adjustable optical attenuator setting is unreasonable
- D. Inhomogeneity of insertion loss of each channel of the combiner/demultiplexer
Answer: B,C,D
NEW QUESTION 150
When deploying ring network protection in the PTN7900 network, which items are wrong?
- A. When configuring a ring network, the east-west interfaces of the ring network can be on the same board
- B. The east-west interface bandwidth of the ring network must be consistent, otherwise the ring network cannot be deployed
- C. The tunnel that carries the service needs to be bound to the ring network, so that the ring network can protect the service
- D. Ring network protection and LSP APS protection can be configured at the same time
Answer: A,B
NEW QUESTION 151
Which of the following is the destination MAC address of the Layer 2 header of the data received by the PTN960 from the LTE base station?
- A. User-side port MAC of the PTN device connected to the base station
- B. The network port MAC of the PTN device connected to the base station
- C. The port MAC of the EPC device connected to the core L3PTN
- D. MAC of the base station gateway L3VE on the L2/L3 node
Answer: D
NEW QUESTION 152
......
Resources From:
- 2023 Latest Test4Engine H35-260 Exam Dumps (PDF & Exam Engine) Free Share: https://www.test4engine.com/H35-260_exam-latest-braindumps.html
- 2023 Latest Test4Engine H35-260 PDF and H35-260 Exam Dumps Free Share: https://drive.google.com/open?id=1fJEaq8owhoyDD2-6ode0EKpCkhznkiGK
Free Resources from Test4Engine, We Devoted to Helping You 100% Pass All Exams!